LOWER MAINLAND, BC Talk directly with Robert · 604-765-8424
BeeWarmHeating · Cooling · Gas fitting
BEEWARM / HOME COMFORT PLANNING

Size up your
heating plan.

Compare your home’s documented heat loss with a proposed system’s heating output. Keep the numbers together, then ask Rob about the next step.

Not sure where to start? Ask Bert Bee ↓
THE HEATING SIZING CALCULATOR

Will the output
cover the load?

Use the design heating load from a heat-loss report and the manufacturer’s heating output at that same outdoor temperature. You can enter each value in a different unit.

1 / Your home’s heat-loss report

Use the calculated heat loss for the home or zone being served—not the old furnace input rating or your floor area.

2 / The proposed equipment

Use delivered heating capacity, not electrical input, cooling tons or a heat pump’s mild-weather rating. Ask the contractor for the performance table if this is missing.

BERT BEE / GUIDED PLANNING

Let’s find
your next step.

Choose what you have. Bert Bee is a guided planning helper with prepared answers; Robert is the person who reviews your project.

Start with the question closest to your situation. No information is sent when you use this guide.

ASK ROB / ROBERT HAMILTON

Make the first
conversation useful.

Add the neighbourhood and equipment model you want Robert to review. Your notes stay in this tab until you choose to share the draft.

This prepares a draft here. It does not send an enquiry or book a visit.

The email link opens your email app. Review the recipient and send it there. No delivery or appointment is confirmed by this tool.

What the calculator does

Heating-load coverage = documented heating output ÷ design heating load × 100. A value below 100% shows a capacity gap at that one outdoor temperature. A value above 100% shows output above the entered load; it does not establish that equipment is correctly sized or efficient throughout the season. The calculation converts 1 kW of thermal output to approximately 3,412.14 BTU/h.

Compare the same home or zone, indoor design conditions and outdoor design temperature. The figures do not predict yearly energy use, bills, grants or equipment eligibility. A planned dual-fuel or supplemental-heating strategy needs a designer’s assessment rather than a pass/fail badge from this calculator.

Natural Resources Canada explains why professional load calculations, climate and equipment performance matter in Heating and cooling with a heat pump. Mechanical designers can use NRCan’s air-source heat pump sizing and selection toolkit.

Plan a heat-pump enquiry · Sketch a measured gas route · Contact BeeWarm